Configuring The Control Unit Lmu Via The Qaa73; 4. Level : Parameter Settings For The End-User - geminox QAA 73.110 Technische Beschreibung

4 - CONFIGURING THE CONTROL UNIT LMU VIA THE QAA73

After setting the parameters via the QAA
73 room sensor (for the 4./5. et 6. Le-
!
vels), and so that the LMU accepts the

4.1 - 4. Level : Parameter settings for the end-user

Enter the control unit LMU via the sensor QAA73
and first level settings.
Buttons
Press on the both line selection buttons
beginning with the button
- This will take you to the first programming mode "LMU"(4. level)
Successive
display:
P R O G
1
et
Press the line selection buttons to select the required line.(rep. b).
- All possible lines are indicated in § 2 - section IV - Parameter list
2
P R O G
Press the plus or minus button to enter the required value (rep. c). The setting will
be stored as soon as you leave the programming mode or change to another line.
3
- The parameter list containing all possible settings is indicated in § 2 - section IV
By pressing the Info button, you leave the programming mode "end-user"
4
b)
- Parameter list
modifications to the settings, press the RESET
button on the boiler control panel, wait for 6 se-
conds and press a second time.
Explanation
and setting buttons
.
- 8 -
OPERATING LEVELS
Line
c)
. . .
Permanent
display