System Operation - Chal-Tec 10027071 Bedienungsanleitung

NOTE: For the first use, you need to connect via P2P (see below) and set WiFi settings before you
process with other modes.
1. P2P connection mode
1. On the camera, put the switch to "AP" position.
2. Download the app "P2PCam Live" to your smart device from iTunes or the Google App Store.
3. Turn on WiFi on your smart device and connect to the camera (default password is "12348765"
– it is highly recommended to change the default password).
4. Open the app "P2PCam Live" and choose "click here to add camera".
There are two possible ways to add the camera:
Click "Scan" to scan the QR code at the bottom of the camera or

 Click "Search" to make the software search for the camera in the WiFi network.
5. Click the camera – you will see the camera's image.
6. To configurate the camera, click "edit camera" -> "Advanced" to gain access to:

Modify security code (recommended!)

Video qualilty and environment mode settings
 WiFi setting (for connecting with your home router's AP)

Event settings

Recording settings
2. Home network mode (camera – home AP – Android/iOS device)
1. Connect the camera to your home network (please refer to 1., step 6 – you need to connect in
P2P mode first).
2. Put the switch on the camera to "Station" position (and restart the camera by pulling out the plug
for a few seconds).
3. Refer to 1., steps 4 to 6.
3. IOT network mode (camera – internet – Android/iOS device)
1. If you have already gone through 1. and 2., your smart device will have saved the camera
information, so you just need to make sure your router is connected to the internet.
Note:
In IOT mode, the camera switch must be in "Station" position. If frame loss occurs, it may be the
result of the network speed. As higher frame rates and higher resolutions need bigger
bandwidths, try to set the recorded image to a smaller rate and resolution (See 1., step 6.)
4. Home PC network mode (camera – router – windows device
1. Put the camera switch to "Station" position
2. Connect the camera to your router via network cable
3. Search the camera by software "IPCSearch.exe" (to be found on included CD).
4. Refresh and double click on the UID of your camera will make your browser pop up.
5. The default password is "admin" – install the plugin according to instructions popping up.- You
should now be able to see the camera's image in your browserr window.
5. Home PC network mode (camera - home AP - windows device )
1. In 4., after connect successful, click "network", then input the wireless AP's information, then
save.
2. Plug off the network cable, plug off then plug in again the power to reboot (switch should be at
„Station" position).
3. Refer to 4., steps 3,4,5
6. Use camera as a wireless repeater
1. Stay connection as 5.4 by network cable to router
2. Put the switcher to "AP" position, plug off then plug in to reboot camera
3. You can use your devices to connect to the camera, refer to 5.1 step3.
4. Now your devices is available to internet
5. Make sure your router is connected to internet
7. Factory reset
Use a pen or similar to reach the reset button on the camera's bottom. Press and hold for 10
1.
sec.

SYSTEM OPERATION