Mounting Triango 100 F - Derungs Dmed Triango 100 Serie Montage- Und Gebrauchsanweisung

ENG
5.3 Mounting the arm for wall-
mounting assemble
WARNING
The opening spring balanced arm is an injury
hazard

Do not remove the transport safeguard until
after the luminaire head has been mounted.

Connect the wall-mounted joint plug to the wall
bracket plug

Connect the wall arm plug to the wall-mounted
joint plug
3
metric
Insert the

arm for wall-mounting 3 into wall
bracket 1 slightly

Insert the sliding piece 2 into the groove
Push up the

arm 3 in such a way that the
hole in the wall bracket is aligned with the hole
in the sliding piece
Screw

grub screw 4 into wall bracket
3
metric
30

In the case of a dead stop, screw this back by
a ¼ turn and check the turning function
6
1
metric
4
metric
2

Move out the arm for wall-mounting in all
positions and align horizontally. Then tighten
the 4 grub screws 2 (5 Nm) as well as the self-
locking bolt 1 with M8 nut (20 Nm).
3
metric

Push cover against the wall and tighten firmly
with end ring (0.5Nm)

Continue with luminaire head assembly, see
Chap.7
6

MOUNTING Triango 100 F

AT THE REAR
AT THE FRONT

Remove the 4 crosstip screws and remove the
power supply pan