Led Indicators For T8642 And T8643 - Axis T864 Serie Installationsanleitung

LED Indicators for T8642 and T8643

LED
Behavior/color
Coax link Off
On
Flash
Orange/red
Ethernet
Off
link
On
Flash
Red
PoE over
Off
coax
On
Red (1 flash)
Red (2 flashes)
Red (3 flashes)
Max PoE On
power
available
Flash
for camera
(Watts)
Orange (flashing)
Red (flashing)
1. Available power is specific to the cable length, type, and power source used, and is calculated
automatically on connection. For example, to ensure reliable power delivery to a PoE IP camera whose
maximum power requirement is 12 watts, check that the 15 watt LED is lit.
2. If installing a PTZ camera, or any equipment whose power requirement can change, check these LEDs
while the equipment is drawing peak power, such as when the PTZ camera is moving.
3. For maximum PoE over coax power, connect an AXIS T8003 PS57 power supply to the Base unit. If more
power is required than the cable can carry, the power supply can be connected to the Device unit.
AXIS T864 Series Multi Channel
Indication
No power
Connection established
Units not detected on coax
Data rate < 100%. The coax connection has reached power
and range limit. Reduce cable distance or connect an AXIS
T8003 PS57 supply to the Device unit.
No network connection
Ethernet link established
Network activity on port
10BASE-T connection. Units must be connected to
100BASE-T (full-duplex) compatible equipment for
effective operation.
Units not detected
PoE over Coax enabled
Low voltage. Check power supply type/polarity.
Short circuit. Check for cable faults and remove legacy
video equipment.
Power disconnected due to overload.
Max PoE power that can be reliably delivered from 5 to
25 watts.
Less than 5 watts of PoE available.
Approaching power limit
1, 2, 3
Power limit reached.
15
EN