Technical Data; Working Modes - REV Solar LED Butterfly Typ LSD-SWL-1.5WPlus-Butterfly Montage- Und Bedienungsanleitung

The deliver consists of:
• Product
• Mounting material (screws, dowels, spacers)
• Instructions

TECHNICAL DATA

• Output: 1,5W LED
• LED illuminant: 14x SMD 2835 LEDs
• Luminous flux: 220lm
• Colour temperature: 4.000K
• Ra/CRI: ≥ 83
• Energy Efficiency Index (EEI): A++
• LED service life: 35000h
• Beam angle: 90°
• IP protection class: IP65
• Protection class: III
• Ambient temperature: -10°C – 25°C
• Dimensions W x H x D: 145 x 212 x 96mm
• Weight: 210g
• Coverage angle: 120°
• Coverage area: 5m
• Battery: 3,7V / 1200mAh / Lithium ion battery / not replacable
• Solar Panel: 0,7Wp / 5V / 0,14A / polycrystalline silicon
INSTALLATION (A1)
• Please use the card to measure hole position correctly and drill 2 holes of ⌀6mm.
• Fix 2 expansion plugs into the holes.
• Fix a screw to the lower expansion plug with a spare space, insert the notch onto the screw.
• Straighten the whole lamp and fasten the upper screw.
• Press the button to adjust to demanded working mode.

WORKING MODES

Please press the Button to select working mode:
• Press 1st time for Mode A
• Press 2nd time for Mode B
• Press 3rd time for off
Mode A: Automatically turns on to full brightness (220lm) when motion is detected in the range ≤5 mtrs and then
turns to weak brightness (front light on & back light on) in 10 seconds of no motion. (A3)
Mode B: Automatically turns on to full brightness (220lm) when motion is detected in the range ≤5 mtrs and then
turns to weak brightness (front light off & back light on) in 10 seconds of no motion. (A4)
NOTICE
• This is a solar powered lamp, please install it in a location where can get enough sunshine.
• The lamp will light up automatically at dusk.
• Please note the lighting time depends on sunshine duration and weather.
• Built-in intelligent IC is with over-charge, over-discharge and over-voltage protection.
CLEANING
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
• Never spray for cleaning or use a steam pressure cleaner, as this may damage the insulation and seals!
GB
9