Technical Specifications - SunStar GUM PowerCARE Bedienungsanleitung

6
4. Push the brush head down until the bottom of the brush head stops at the top of
the handle. (See Figure 1-1 and 1-2).
Compatible only with GUM® PowerCARE™ replacement brush heads. Other brush
heads are not approved for use on this product and may void the warranty.
HOW TO CLEAN THE TOOTHBRUSH AND CHARGER BASE
Important: Clean the brush handle and brush head
after every use to optimize the useful life of your
power toothbrush.
1. Handle and brush head:
a) Rinse the brush head under running water until
clean. (See Figure 3)
b) With handle switched off, remove brush head. (See
Figure 2) Rinse handle, including the area around
the metal shaft where the brush head attaches, in
lukewarm running water. (See Figure 4)
c) Wipe handle and brush head dry. (See Figure 5)
d) Reinsert brush head onto handle.
2. Charger base:
a) Unplug before cleaning.
b) Clean charger base with a damp cloth. (DO NOT
immerse in water or other liquids, rinse with water, or
insert into water to clean.) Make sure that it is com-
pletely dry before plugging it back into the electrical
outlet. (See Figures 6 and 7)

6. TECHNICAL SPECIFICATIONS

Battery specifications
Two nickel-metal hydride (Ni-MH) rechargeable
batteries: 2.4V DC
Free from cadmium, lead and mercury.
Charger power supply
• Input: 220-240V~50Hz
• Power: 0.9W
Do not plug into an electrical outlet with a voltage
other than specified above.
7. DISPOSAL
Environmental Notice
This product contains recyclable electric was-
te and nickel-metal hydride (Ni-MH) rechar-
geable batteries. To protect the environment
and human health, do not dispose of product
in daily household waste. Once toothbrush
has reached the end of its useful life, or has
been damaged, please take the entire handle
to your local recycling center for disposal.
IP67
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7