Legamaster LS2000 Benutzerhandbuch Seite 5

4. OPERATING THE SOUNDBAR
POWER SUPPLY
Plug the AC power cord of the 19v adapter into a suitable AC power-outlet, and connect the other end to the power-port of the soundbar.
SOURCE
Connect a source to the soundbar using a suitable cable. Connect the cable to the RCA, AUX, Optical or USB port of the soundbar, or use
the 3.5mm/RCA adapter to connect the cable.
SOURCE SELECTION
Use the source-selection button on the soundbar, or the source-buttons on the remote control to select the proper source. The indicator-light
on the front of the soundbar will change color to show the different sources selected
SOUND AND VOLUME SETTINGS
Use the volume up and down buttons on soundbar or remote to adjust the volume.
Using the DSP buttons
(MOVIE, MUSIC, DIALOG)
adjust the sound settings
(bass / treble)
With the BASS- and BASS+ buttons on the remote, the bass output can be regulated to your liking.
With the TREBLE- and TREBLE+ buttons on the remote, treble can be set to your liking.
CONNECTING A BLUETOOTH DEVICE
Pairing a new device is only possible when no other devices are connected.
Using the source selection button, or the BT button on the remote, switch to Bluetooth mode. The indicator will light up blue
or will blink blue when in pairing mode.
already paired)
On a Bluetooth-enabled device, open the Bluetooth-settings. Make sure Bluetooth is enabled. Connect your device to by selecting LS2000
from the list of devices.
To disconnect your device, hold the BT button for a few seconds.
USER MANUAL
on the remote, pre-set setting can be chosen that
for specific scenario's.
LS2000 / LS3000 – USER MANUAL – ENGLISH
(see above for color-explanation)
3
.
(when a device is