Herunterladen Diese Seite drucken

Lenze AC Tech EZXDB371_A1 Bedienungsanleitung Seite 2

Werbung

EZXDB371_A1...EZXDB752_A1 (0.25 - 7.5 kW)
ENGLISH
The DB module is a heat producing device; DO NOT mount the DB module below the controller!
The DB module must be mounted above or to the side of the controller.
The Dynamic Braking option terminals have a basic isolation (single insulating distance).
DEUTSCH
Das Bremsmodul strahlt Wärme ab. Die Montage des Bremsmoduls unterhalb des Frequenz-
umrichters ist NICHT zulässig! Das Bremsmodul muss entweder neben oder über dem Frequenzumrichter
montiert werden.
Das Bremsmodul Steuerklemmen sind basisisoliert (einfache Trennstrecke).
FRANÇAIS
Le module de freinage est un appareil produisant de la chaleur. NE PAS installer le module
de freinage sous le convertisseur de fréquence ! Le module de freinage doit être installé à coté ou au-
dessus du convertisseur de fréquence.
Le Frein Dynamique bornes de commande possèdent une isolation de base (espace interborne simple).
ITALIANO
Il modulo DB genera calore; NON montare il modulo DB sotto l'inverter! Il modulo DB deve
essere montato sopra o a lato dell'inverter.
La frenatura dinamica opzionale i terminali possiedono un isolamento di base (distanza di isolamento singola).
ESPAÑOL
El módulo DB es un equipo disipador de calor; NO montar el módulo DB tras el convertidor!
El módulo DB se debe montar en la parte superior ó lateral del convertidor.
La opción de freno dinámico terminales tienen un aislamiento básico (distancia simple de aislamiento).
SMV
Parameter Setting
Parametrierung
Paramétrage
Configurazione parametri
Ajuste de parámetros
or
• P121, P122,
P123 = 21
oder
o, ou
• P142 = 24
Installation • Installazione • Instalación
< _ 1.5 mm²
7mm
0.2 Nm / 2 lb-in
6 mm /0.24 in
2.5mm² /AWG 14
0.5 Nm / 4.5 lb-in
6 mm /0.24 in
2.5mm² /AWG 14
(16 AWG)
EZXDB...A1
42 43 46 47
P120 = 02
46 47
4 13x
14 11 4 13A 13B 13C
SMV
2
Note:
The Dynamic Brake
connector is located
on the opposite side
in the Nema 4X/IP65
version of the SMV
inverter.
0.5 Nm/ 4.5 lb-in
6 mm /0.24 in
1.5mm² /AWG 16
_
L < 30 cm
B- B+
P120 = 01
46 47
4 13x
B- B+
PE
R+ R-

Werbung

loading

Diese Anleitung auch für:

Ezxdb112_a1Ezxdb222_a1Ezxdb402_a1Ezxdb552_a1Ezxdb752_a1