Disassembly - WilTec 50790 Bedienungsanleitung

Disassembly

To disassemble the Drywall Lift for transport or
compact storage;
12. Crank the cradle all the way down.
13. Slide the cradle outriggers all the way in until
they latch. Close the panel support hooks.
14. Remove the crossarms by pressing the spring
tab on the bottom and sliding the crossarm
out of the tapered socket.
15. Unlock the cradle tilt latch. Lift the cradle
(about 3 in.) until you can remove it from the
frame.
16. Rotate the winch wheel one full rotation for-
ward as shown. This will raise the inner tele-
scoping section.
17. Unlock the winch assembly by lifting the slide
bar with your left hand while you rotate the
slide bar lock counterclockwise with your right
hand.
18. Hold the slide bar lock in this disengaged po-
sition (step 6). and press down on the tele-
scoping sections in the frame with your left
hand. The winch assembly will move toward
the frame housing.
19. Crank the telescoping sections all the way
down. Swing up the retaining hook as shown,
and crank the telescoping sections back up
slightly until secured by the hook.
20. Hold the retaining hook in this position with
your left hand, and rotate the winch forward
with your right hand.
The winch assembly will fold up against the
frame. When the slide bar contacts the frame,
tighten the cable by turning the wheel further
(just enough to hold the winch assembly in
this position).
21. Carefully lift the frame/winch about 1 in. to
free it from the tripod base.
22. To fold the base, press down on the slide
yoke ring and pivot the forward legs in until
they lock in the closed position.
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
Seite 25