Selecting Another Group; Abandoning The "Manual" Mode; Operation In "Manual With Recorder" Mode Man - Stobag SKIMY SRCW 06T Anweisungen Und Hinweise Für Den Installateur

Table 17

Selecting another group

1. Press key
2. Now you can use keys
Table 18 Assembling a multiple group and sending a command
Starting from the 1st group, press key
1.
group.
2. Press key
3. Repeat the two previous steps to select other groups.
4. When the multiple group has been assembled, you can use the following keys
■ ▼ to send the commands.
Note: if you select and confirm the wrong group, you can delete it by repeatedly pressing key
eliminated starts flashing, then press key
Table 19 Sending a special command to a group or multiple group
Starting from the 1st group, press key
1.
group.
2. Press key
3. Repeat the two previous steps if you wish to select other groups.
4. Press key
starts flashing.
5. Press key
6. Now you can use the following keys
Table 20 Abandoning the "manual" mode and returning to the selection menu:
After sending a command, press key
Or:
Make sure that no group has been selected then press one of the following
keys:
them by pressing key
Or:
Press key ■ repeatedly a number of times until Auto starts flashing.

4.5) Operation in "Manual with recorder" mode Man

Table 21 Selecting the "manual with recorder" mode
Press key ■ repeatedly a number of times until Auto starts flashing.
1.
2. Press key
3. Press key
From this moment you can use SRCW 06T as if it were in "manual" mode, except that all the commands transmitted using
or ▼, together with the day, hour and minute on which they were transmitted, will be memorized as events.
key
Note: the "manual with recorder" mode does not enable the recording of events containing the "■" command.
A tip for the inexperienced: This operating mode is used to memorize events without having to program them one
by one. To record events that normally take place in the course of an entire week, access the "manual with recorder"
mode at the beginning of the week, then use SRCW 06T to command the daily up and down movement of the automa-
tions every day at the desired time. At the beginning of the following week, set SRCW 06T to the "automatic" mode;
at this point the events will be repeated automatically through all the following weeks.
To delete an event recorded by mistake, see chapter 5.2.3.
www.stobag.com
repeatedly in order to select the desired group.
■ ▼ to send commands to the selected group.
to confirm the group.
.
to confirm the group.
repeatedly until the special command symbol "
to confirm the special command.
■ ▼
(if necessary, select the groups by pressing key
).
twice until Man starts flashing.
to confirm the "manual" mode with recorder.
repeatedly in order to select another
repeatedly in order to select another
" or "
■ ▼ to send the special command.
.
and deselect / select
Example
...
Example
...
until the group to be
Example
...
"
... or
Example
... Auto
Example
... Auto
Man
71
GB