MYDLINK DCS-8000LHV2 Installationsanleitung Seite 8

1
/
2
/
3
/
8
Mounting
Position the baseplate on
the wall. Keep it in the same
place while using a pencil to
mark the two holes.
Drill two 25mm deep holes
with a 6mm drill bit over the
pencil marks. If necessary,
hammer in the plastic wall
anchors to support the
screws.
Place the baseplate on the
wall where you can see
both holes through the
baseplate. Screw the screws
into the wall to secure the
baseplate.
DCS-8000LHV2