Traxxas 7971 Montageanleitung

Camera/Gimbal Mount Assembly Instructions
Kit contents:
• Upper mount half
• Lower mount half
• Rubber isolators for fixed camera bracket mount assembly (4)
• Rubber isolators for 2-axis gimbal mount assembly (4) (marked with yellow dot)
Tools required:
• Needle nose pliers
Mount Assembly for use with fixed camera bracket
A
C
Traxxas, 6250 Traxxas Way, McKinney, TX 75070, Phone: 972-549-3000, Fax: 972-549-3011, e-mail: support@Traxxas.com
B
4
3
2
1
Final Assembly
T R AXXAS. com
Mount Assembly
1. Slide the upper mount half under the lower mount half (A).
2. Flex the upper mount half to align the eyelets above the lower mount half eyelets on
each corner of the mount (B). Refer to Figure B for the order of eyelet alignment (1-4).
3. Use needle nose pliers to install the rubber isolators into the eyelets on each corner
between the two mount halves (C).
Mount Assembly for use with 2-axis gimbal
A
C
Covers Part #7971
B
4
3
2
1
Final Assembly
KC2361-R00 Rev 151217