Wiring Instructions - Hive NEÖS 1000cc Bedienungsanleitung

EN
NEÖS INSTRUCTIONS MANUAL
Heating of a vast range of waxes providing flexibility to use the wax of your choice.
Sealed heat chambers that have been specially designed for direct pouring of particular
wax types and treatments.
Alternative wax in metal tins can be directly inserted into heater to melt the wax, allowing the wax container
to be removed and sealed at the end of use. This is ideal when undertaking mobile waxing treatments.
Wide range of operating temperatures available, designed to suit all types of waxes –
warm and crème strip waxes, hot waxes and paraffin waxes.
For professional use only.
1000cc/500cc Instructions for use
• Remove lid and either:
> Fill the inner chamber directly with the wax of your choice.
> Or insert a suitable tin of wax into the inner chamber.
• Connect the removable cord into the heater and plug into the mains power supply,
then press on/off switch.
• Move regulator temperature control clockwise to a setting suitable to the type of wax
to be used.
• The thermostat indicator will remain illuminated until required temperature is reached; thereafter the
thermostat will automatically switch the unit off/on to maintain the chosen heat setting.
• The temperature regulator can be moved clockwise to increase the temperature and
anti-clockwise to reduce the temperature.
200cc Instructions for use
• Remove lid and fill the inner chamber directly with the wax of your choice.
• Plug the unit into the mains power supply, then press the on/off switch.
• Move regulator temperature control clockwise to a setting suitable to the type of wax
to be used.
• The temperature regulator can be moved clockwise to increase the temperature and
anti-clockwise to reduce the temperature.
Recommendations
Having established the ideal working temperature for the chosen wax, we advise that the thermostat
setting is recorded or maintained and the on/off switch used in isolation.
To avoid loss of profitable working time, we suggest that the heater is switched on approximately
30 minutes before treatments are due to commence to ensure that the product has reached the correct
operating temperature and consistency.

Wiring Instructions

The heater is fitted with a standard 13 amp plug and a 3 amp fuse. If the unit fails to operate,
replace the fuse with a standard 3 amp cartridge fuse.
DO NOT use a fuse with a higher rating.
NOTE: This applies to UK 3 pin plugs only.
WARNING: This appliance must be earthed (not applicable to 200cc model).
HIVE A5 Wax Heater Instruction Manual.indd 2 HIVE A5 Wax Heater Instruction Manual.indd 2 09/06/2016 12:00 09/06/2016 12:00