Watchguard Firebox M370 Kurzanleitung Seite 5

Install Interface Modules
For the Firebox M470, M570 and M670 you can install any supported interface module. You must
install the interface modules before you can enable the interfaces in the Firebox configuration. The
supported interfaces modules are:
• WatchGuard Firebox M 8 Port 1Gb Copper Module
• WatchGuard Firebox M 8 Port SFP Fiber Module
• WatchGuard Firebox M 4 Port 10 Gb SFP+ Fiber Module
Important: You must power off the Firebox before you install or remove an interface module.
For details about available interface modules and installation instructions, see the Hardware Guide
available at: www.watchguard.com/help/documentation/hardware.asp
Install Your Firebox
For instructions to install your Firebox in a network rack, see the Firebox M370/470/570/670
Hardware Guide.
Reset the Firebox to Factory-Default Settings
If you ever need to, you can restore your Firebox to its factory-default settings. For example, if you do
not know the administrator account passphrase or you want to start over with a new configuration,
you can reset your Firebox. Make sure you back up your Firebox configuration before you reset your
Firebox in case you want to restore it in the future.
For information about how to reset your Firebox, see the Firebox M370/470/570/670 Hardware Guide,
available at: www.watchguard.com/help/documentation/hardware.asp
5