Velleman components CTC717 Bedienungsanleitung Seite 3

NOTE:
- The maximum length of a phone number is 27 digits including ∗ and #.
- Pressing "CLR" during programming will abort the operation and the dialler will return to normal mode.
- ∗ in a phone number represents a 3 second delay ; the dialler will not dial "∗".
- # represents a 5 second delay ; the dialler will not dial "#" except when it's at the end of a phone number.
- Storing a pager number: (pager number + ∗ + # + identity code + # + "OK"). The identity code enables the
recipient to recognize the call as coming from the auto dialler. Use any number of ∗ or # to match the protocols of
the pager system used in your area.
- Storing a telephone number in EPABX phone system: (EPABX access code 0/9/8 + ∗ + tel nr + "OK"). Add as
many ∗ as required.
- Storing a telephone number with extension: (tel nr + ∗ + ∗ + extension nr + "OK"). Add as many ∗ as required.
b. Edit or Erase Telephone Numbers
Follow the same steps as to store a telephone number. The old number will automatically be overwritten.
If you do not enter a telephone number but press "SET" straightaway, the previous number will be erased.
c. Record Messages
The CTC717 allows you to record 5 messages, each with their specific maximum duration:
Message#1: Burglar (3 seconds)
Message#2: Fire (3 seconds)
Message#3: Panic (3 seconds)
Message#4: Medical (3 seconds)
Message#5: Common Address (8 seconds)
To record these messages, follow these 3 steps:
1. In normal mode, press the "REC" key to enter recording mode ; the red and yellow LEDs will light up.
2. Enter the message number and press "REC" again ; you will hear a long beep.
3. Record your message and press "CLR" when done or wait for the timer to run out.
IMPORTANT: message#5 has to be recorded for the dialler to work properly. If message#5 is not recorded,
the dialler will not respond to any alarm signals!
d. Edit or Erase Messages
To edit a message, follow the same steps as to record a message ; the previous message will be deleted.
To erase a message, follow these steps:
1. In normal mode, press the "REC" key to enter recording mode ; the red and yellow LEDs will light up.
2. Enter the message number and press "CLR" to erase that message
- OR - press "0" and "CLR" to erase all messages ; a sound signal indicates that all messages have been erased.
9. Testing the CTC717
IMPORTANT: Make sure message#5 is recorded before testing! (cf. "c. Record Messages" above)
a. Test Dial the Telephone Numbers
1. From normal mode, press the "TEST" key (#9) to enter the test mode. The yellow LED will start to flash.
2. Enter the "priority order number" (11-16, 21, 22, 31, 32, 41 or 42) ; the dialler will dial the number and play the
according message.
CTC717 - 3 - VELLEMAN