Using The Vacuum Cleaner; Cleaning And Care - Vitea Care VT-1892 B Betriebsanweisung

cushions, but for collecting dust from furniture
surface as well, the pile on the brush (24) pre-
vents damage of polished furniture surface.
Using the dustbag
1 cloth dustbag and 3 paper dustbags are sup-
plied with the unit.
•
Open the dustbag compartment lid (16) by
pressing the clamp (17).
•
Take the dustbag holder (23) and pull it
to remove dustbag holder (23) from the
clamps (22).
•
To install the dustbag (26) back to its place,
insert the dustbag holder (23) into the
clamps (22).
•
Close the dustbag compartment lid (16).
Note: Always make sure that the dustbag (26)
is installed properly before closing the lid (16).

USING THE VACUUM CLEANER

Safety measures
•
Do not use the vacuum cleaner near hot
surfaces, ashtrays and in the places where
inflammable liquids are stored.
•
If the suction power of the vacuum cleaner
decreases rapidly while cleaning, switch it
off immediately and check the telescopic
pipe and the flexible hose for obstruction.
Switch the vacuum cleaner off, then unplug
it, remove the obstruction and only after that
continue cleaning.
USING THE VACUUM CLEANER
Attention! Always switch the vacuum cleaner
on only with the dustbag (26) and inlet (21)
and outlet (12) filters installed. Always make
sure that the filters are installed properly.
• Before using the unit, unwind the power cord
to the required length and insert the power
plug into the mains socket.
•
The yellow mark on the power cord indicates
the maximum cord length. Do not unwind the
power cord further than the red mark.
•
Press the ON/OFF button (9) to switch the
vacuum cleaner on.
•
During the operation you can control the suc-
tion power using the suction power control (10).
•
After room cleaning switch the vacuum
cleaner off by pressing the ON/OFF button
(9) and unplug the unit.
•
To wind the cord press the cord winding but-
ton (11), hold the winding cord with hand to
avoid its whipping and damage.
VT-1892.indd 5

CLEANING AND CARE

•
If full dustbag indicator (13) turns «red» during
operation, replace the paper dustbag or clean
up the cloth dustbag.
• Before cleaning or replacing the dustbag (26)
switch the vacuum cleaner off and unplug it.
• Provide that the inlet filter (21) and the outlet
HEPA filter (12) are always clean, because the
overall performance of the vacuum cleaner
depends on it; clean the filters no less than
3-4 times a year, and more often at severe
obstruction.
Cleaning the inlet filter (21)
•
Switch the vacuum cleaner off and unplug it.
•
Open the dustbag compartment lid (16) by
pressing the clamp (17). Remove the dust-
bag (26).
• Take the inlet filter (21) and remove it from the
holders (20) pulling it upwards.
• Wash the inlet filter (21) with warm water, dry
thoroughly and install it into the filter hold-
ers (20).
• Install the dustbag (26) back to its place.
•
Close the dustbag compartment lid (16).
Cleaning the outlet HEPA filter (12)
•
Switch the vacuum cleaner off and unplug it.
•
Remove the outlet filter grid (7) by press-
ing the clamp (8) and remove the HEPA fil-
ter (12).
•
Wash the HEPA Filter (12) under slightly warm
water jet. Do not wash the HEPA filter (12) in a
dishwashing machine.
•
Dry the HEPA filter. Do not dry the HEPA filter
with a hairdryer.
•
Install the HEPA filter (12) back to its place.
• Install the outlet filter grid (7) back to its place.
Notes:
Before installing the filters (12, 21) make sure
–
that they are dry.
Do not dry the filters (12, 21) with a hairdryer.
–
Vacuum cleaner body
Wipe the vacuum cleaner body with a soft,
–
slightly damp cloth and then wipe it dry.
Do not immerse the body of the vacuum
–
cleaner, the power cord and the power plug
of the unit into water or other liquids. Provide
that no liquid gets inside the vacuum cleaner
body.
Never use solvents or abrasives to clean the
–
surface of the vacuum cleaner.
5
ENGLISH
03.12.2015 17:47:49