Switching Off; Turn Off; Malfunctions - FireWare Nimbo Gebrauchsanweisung

User Manual
EN
FireWare Nimbo
Take note: Make sure the fluid is clean at all times, so no dirt or dust can be sucked into the pump.
1. Position the FireWare Nimbo on a level surface and unscrew the tank filler cap (3).
2. Pour the FireWare Smoke Fluid in the fluid tank using a funnel and close the tank filler cap
firmly. Clean any possible fluid spillage using a dry cloth.
Take note: Make sure none of the spilt smoke fluid runs into the machine. This may cause irreparable
damage.
3. Connect the remote control to the input at the back (7).
Take note: Only use FireWare water-glycol based standard smoke fluid. Other smoke fluid will block
the evaporator and severely damage the machinery.
4. Connect the plug to a grounded power outlet and turn on the smoke generator (10). It
takes less than 2 minutes for the smoke generator to heat up. During warming up, the led
indicators will be flashing on the handle (1) and on the remote control (11).
Once the machine is warmed up, the indicators will burn continuously.
5. Push on the starter button (1 or 12) to generate smoke. As long as you keep the button on
the machine pushed in, the Nimbo will generate smoke. The machine stops when you
release the button or when it has to heat up anew. With the remote control you can stop
the smoke by pressing the button again. When the machine starts heating up
again, you will see the led indicators blinking again.
Take note: Never push on the starter button if there is no fluid in the tank. If the tank is empty
when you try to generate smoke, the pump will be damaged irreparably! If you notice the machine
is generating (almost) no smoke or is making a loud, rumbling sound, disconnect it from the power
immediately and contact FireWare.
5.

Switching off

Release the start button to stop the smoke and switch the Nimbo off at the On/off button at the back
(10). Always allow the machine to cool off completely before you put it away.
Take note: If you will be transporting the FireWare Nimbo, you must first pour out the fluid from the
fluid tank. Make sure you allow the machine to cool first!
6.

Malfunctions

Problem
The machine doesn't
generate any smoke.
The smoke generator
makes a loud, booming
sound during smoking.
Other
www.FireWare.nl
Possible cause
The fluid tank is
empty.
The machine is not
getting any power.
The pump is running
dry: AVOID THIS AT
ALL TIMES.
Solutions
Switch off the device, allow it to cool and top up
the fluid tank.
Check the cables and power supply.
Switch off the device, allow it to cool down and
top up the fluid tank.
Contact FireWare.
Afbeelding 2
FireWare Nimbo 19