Axxion FSP-010 Kurzanleitung

®
FRONT PANEL
TOP COVER
TO OPEN THE BATTERY CASE:
Following the direction of OPEN mark on the top cover
and press - slide - pull up the top cover at the same time
as shown in the figure 1 and 2.
ENGLISH
1. CONTENTS
Active speaker system x 1
User Manual x 1
2. SAFETY NOTES
*Do not use or install the speakers in the following places:
Very dusty / sandy / hot / humid places.
Near TV / clock / watches; or credit cards, bank cards.
*Take the battery out of the battery case if not playing the unit
for a certain period of long time.
*Do not drop this unit or expose it to strong shock.
3. POWER SUPPLY : 1.5V AAA BATTERY x 2
Open the left speaker and the right speaker.
Open the battery case cover on the top panel.
Insert the batteries with the correct polarity.
Close the battery case cover.
4. CONNECTION
Open the left speaker and the right speaker.
Connect the attached audio cable to the earphone jack of
desired audio source device. Power on the audio device.
5. POWER ON/OFF
Switch the ON/OFF key to left side.
ACTIVE SPEAKER SYSTEM
REAR PANEL
CONNECTION MAP
Press 1 time again if want to power off.
6. VOLUME CONTROL
Increase + /decrease - the volume from the connected
audio source until meet satisfied volume strength & voice
quality .
NOTE: Do not turn the volume too closing to either minimum
or maximum level of the connected audio source,
for which might get serious distortion.
7. SPECIFICATION
*SPEAKER UNIT: 50mm full-range, Impedance 4
*EFFECTIVE POWER: 0.5W + 0.5W (10% THD 1KHz)
*APPROXIMATED PLAYING TIME: (ALKALINE) 4 hours
*POWER REQUIREMENT:
DC3V (170mA), 2 x 1.5V AAA battery.
*SENSITIVITY:89+/-3dB
*AUDIO CABLE: 28 +/- 1cm
*PLUG TYPE: L-type stereo mini plug (3.5mm)
*FREQUENCY RESPONSE: 300Hz-1KHz at 1V
*UNIT DIMENSION: (folded) 18*85*55(W*D*H)
*UNIT N.W.= 80g without batteries
§ Specifications are subject to change without notice.
U s e r s Manual
Model No.: FSP-010
1.