Additional Menu Items - Sony DSBK-2020 Installationsanleitung

Note
Always verify that the unit is operating properly before use. SONY WILL NOT BE
LIABLE FOR DAMAGES OF ANY KIND INCLUDING, BUT NOT LIMITED TO,
COMPENSATION OR REIMBURSEMENT ON ACCOUNT OF THE LOSS OF
PRESENT OR PROSPECTIVE PROFITS DUE TO FAILURE OF THIS UNIT, EITHER
DURING THE WARRANTY PERIOD OR AFTER EXPIRATION OF THE
WARRANTY, OR FOR ANY OTHER REASON WHATSOEVER.

Additional Menu Items

Item number
018
338
618
20 Overview
When this board is installed in the DSR-2000/2000P/2000A/2000AP,
the following additional items appear in the setup menus.
For details of how to use the menus, refer to the Operating Instructions for the DSR-
2000/2000P/2000A/2000AP.
In the table, the underlined settings are the factory default values.
Item name
UP CONVERTER
LINE SELECT
(UP CONV LINE)
9PIN TC PHASE
(9P TC PHASE)
UPCONV
EMBEDDED VITC
(UP CONV VITC)
Settings
Set the line standard conversion (1080i/
720P) for HD SDI output.
1080i: Select 1080i
720P: Select 720P (59.94 Hz only)
Note
If the setting is changed, the new setting will
be effective when the power is turned on after
once turned off.
Set the basis for response to timecode
sensing through the DSR-2000/2000P/
2000A/2000AP RS-422A remote connector.
SD: Set to SD output phase
HD: Set to HD output phase
Note
When this unit is used as a linear editing
feeder through an HD SDI connection, using
the 9-pin (RS-422A) remote control interface,
select "HD".
For the VITC embedded in the HD SDI
output, select whether to use the VITC or TC
recorded on the SD tape.
TC: Use the TC
VITC: Use the VITC