Rear Panel And Connections - Wilson SUB 10 Bedienungsanleitung

Rear panel and connections

Before any connections are made, please ensure that all equipment in the system is turned off.
1. Volume control, adjustable
2. Cross-over/Frequency control, adjustable
3. Phase setting switch
4. Power switch ON/OFF
5. Fuse holder, if use needs to be replaced only use same type and value.
IMPORTANT: unplug the power cable from mains socket before opening the fuse holder.
6. Power input socket, notice that the power cable should be pulled from mains socket if
not used for a longer period
7. Right/Left and +/- speaker cable to stereo speakers
8. Right/Left and +/- speaker cable from amplifier/receiver
9. Auto Standby switch
in "AUTO" position the subwoofer will go into stand-by after not playing for 13 min.
●
in "ON" position the subwoofer will remain powered on.
●
in "OFF" position the subwoofer will remain in standby.
●
10. Line input
10
9
8
7
EN
/
1
2 3
4
4
5
6