Magnat MC 200 Wichtige Hinweise Zur Installation / Garantieurkunde Seite 17

OPERATIONAL ELEMENTS AND CONNECTIONS – FRONT PANEL
15 DISPLAY
The following information is indicated in the
display:
• Selected audio input
• Volume information
• Station and reception information in FM and
DAB mode. See also the DISPLAY button on
the remote control in this regard.
• When the CD input has been selected (no CD
inserted):
NO disC
• After a CD has been inserted and read: T o t a l
number of tracks on the CD, total playing time
of the CD in minutes and seconds
Cd 15 46: 3 2
• If there are MP3 or WMA files on the CD, the file
type and number of files on the CD are displayed:
MP3 15 FiLEs
• When playing a CD:
OPERATIONAL ELEMENTS AND CONNECTIONS – REAR PANEL
180°
12 11
13
1
2
Internet CD Receiver
Art.-Nr. 149 522
Currently played track, elapsed time of the
track:
02 03: 4 5
• The operating status is also indicated by the
following symbols:
► Playback
II Pause
• CD text, ID3 tags
If the CD supports CD text or the MP3 or WMA
files contain ID3 tag information, these are
displayed in the 2nd line of the display. See also
the REMOTE CONTROL section in this regard.
16 SENSOR FOR THE REMOTE CONTROL
Please aim at this sensor when using the remote
control.
10 9 8 7 6 5 4
3
OPERATIONAL ELEMENTS AND CONNECTIONS – REAR PANEL
1 POWER SWITCH
Switches the device on and sets it in the standby
mode. If the switch is set to the "OFF" position,
the device is disconnected from the mains
supply.
2 MAINS CONNECTION
For connecting the supplied mains cable. The
safety fuse should only be changed by qualified
service personnel.
3 SPEAKER TERMINALS
For the connection of stereo speakers with
an impedance rating of 4-8 ohms (the correct
polarity must be taken into account). (See also
INITIAL OPERATION).
ANALOGUE RCA CONNECTIONS (4 - 7)
For connecting analogue audio sources. Please
observe the coloured marking of the sockets and
connectors. Red is always the right channel.
4 SUB OUT
Output for connecting an active subwoofer.
5 REC OUT
For connecting devices for analogue sound
recording (e.g. tape recorder). The signal for the
selected audio source with fixed level applies for
this output, i.e. it is independent of the position
of the volume knob.
6, 7 AUX INPUTS
Connecting other audio sources (e.g. MP3 or
Minidisc player).
17
8 DAB/FM ANTENNA CONNECTION
For connecting the supplied DAB/FM antenna or
a house antenna.
9 DIGITAL IN OPT, COAX
Connect the MC 200 to the digital output on
your CD player/computer/games console/
network player, etc. by using an optical or coaxial
digital audio cable.
10 BLUETOOTH ANTENNA
11 UPDATE
This connection is intended exclusively for system
updates.
12 LAN SOCKET
For connection to the router or the network.
13 WLAN ANTENNA
180° rotable WLAN antenna.