Inova Peachtree Audio Anleitung Seite 16

Amplifier
ST MOSFET amp modules
80 watts per channel at less than .1% distortion into 6 ohms
Sigma Servo internal wiring configuration for better damping
Preamplifier
Hybrid tube design (6N1P)
7.0V output @ 2.0V input
<1 ohm at output stage
Class A output stage
Polypropylene caps in the signal path
Headphone Amp
Suitable for all electrodynamic headphones
Output impedance: <1 ohm
Maximum output power: 100mW into 8 ohms / 300mW into 150 ohms / 150mW into 300 ohms
Class A output stage
6N1P vacuum tube in circuit
DAC
6 digital inputs USB, 2 Coax, 2 Optical, 1 iPod dock
ESS ES9016 Sabre³² Ultra DAC
24Bit/96kHz USB capability
24Bit/192kHz SPDIF capability
11 regulated power supplies
Organic capacitors
Class A output stage
Transformer-coupled digital inputs for ground isolation
Galvanically-isolated USB stage
>122dB signal to noise ratio
<3 picoseconds jitter measured at the master clock
Size: 5" H x 14 ¾" W x 14" D (including volume knob and speaker terminals)
Weight: 26 pounds
(shared with the Pre Out stage)
Expected life of the 6N1P tube
is 10,000 hours.
Tec h ni ca l
S pe c if ic at io n s
14