AVIRE MEMCO Pana40 Plus2D Einbauanleitung

Pana40 Plus2D / 3D
Installation Guide
Ref no. 740 850ML Version 1
Detector Installation
The Pana40 Plus standard detectors have been designed
so that they can be mounted flush with the leading edge,
or as far back on the car door as required in order to deter
vandalism.
Installation Notes 2D / 3D
1. Use fixing kits provided with the detectors, see below
'Mounting Diagram' different installations and mounting
kits.
2. Detectors with the 'earth' wire must be fitted to ensure
that the unit is properly grounded.
3. Plastic filter on 744 profiles has to be removed before
mounting; this is done by removing top end cap screws
and sliding filter out. Once detector is fitted, slide filter
carefully back in with end cap.
Installation Notes 3D
1. The detectors must be installed 5mm above sill, and
set no more than 10mm apart when the doors are fully
closed and aligned within the detector's centre line. This
is to ensure reliable operation of the 3D self-test that is
performed when the doors have closed.
2. The 3D TX detector should be mounted on the left and
the 3D RX on the right when viewed from the landing.
3. Detectors should be aligned as closely as possible for
reliable operation.
4. 3D Switch Settings are detailed on the inside of the Main
3D Controller.
The Pana40 Plus 3D detectors must be fitted flush with
the door edge. This is to allow the infra-red light for 3D
operation to project onto the landing.
4. Position the detectors on the doors approximately 5mm
above the sill.
5. Mark or spot through the 5 fixing holes.
6. Remove the detectors from the door before drilling.
7. Screw the detector to the door using the fixing kits
provided.
8. If the TX and RX detector positions are reversed only on
2D profile then countersunk screws can be used to screw
the detector to the door.