Basic Troubleshooting - Pride Mobility TravelScooter series Betriebshandbuch

V I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device occasionally requires some troubleshooting. However, most of the
problems that may arise can usually be solved with a bit of thought and common sense. Many of these
problems occur because the batteries are not fully charged or because the batteries are worn down and can
no longer hold a charge.
DIAGNOSTIC BEEP CODES
The diagnostic beep codes for your Travel Scooter are designed to help you perform basic troubleshooting
quickly and easily. A diagnostic beep code will sound in the event one of the conditions listed below
develops. Depending on the model you own, your Travel Scooter will communicate by one of the coding
methods as follows:
1. A beep code will begin with a series of fast beeps directly followed by slower beeps which indicates the
actual code. The beep code is only beeped once. To repeat the beep code, remove the key, then reinsert
it and turn it to the "on" position, OR
2. A beep code will identify the condition, pause, then repeat the beep code. The beep code will continue
to alert you in this manner until the scooter is turned off.
NOTE: Your Travel Scooter will not run unless the beep code condition is resolved and the Travel
Scooter has been turned off, then turned back on.
BEEP CODE
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
What if my Travel Scooter does not move when I press the throttle control lever?
When the manual freewheel lever is pushed forward, the brakes are disengaged and all power to the
motor/transaxle assembly is cut.
Pull back on the manual freewheel lever, turn the Travel Scooter off, and then back on to return to
normal operation.
26
CONDITION
Battery voltage is too low to operate the
Travel Scooter.
Battery charge is too low.
The Travel Scooter's battery voltage is too
high to operate the scooter, or the charger is
still connected to the off-board charger port.
Current limit time out.
The manual freewheel lever is in the (for-
.
ward) freewheel position
Throttle control lever not at center position
at start up.
Speed pot error.
Motor volts error.
Other internal errors.
SOLUTION
Charge batteries as soon as possible.
Charge batteries.
Unplug charger and/or turn key off, then back
on again. If traveling down a slope, reduce
Travel Scooter speed to the minimum setting.
Turn the Travel Scooter off for a few minutes,
then turn your Travel Scooter back on.
Remove the key from the key switch, then push
the manual freewheel lever to the drive (rear-
ward) position and restart your Travel Scooter.
Verify that the batteries are fully charged. If the
batteries are fully charged,
throttle control lever to center position, turn
Travel Scooter off then back on.
Contact your authorized Provider for
assistance.
Contact your authorized Provider for
assistance.
Contact your authorized Provider for
assistance.
Travel Scooter Series
then return the