Manual Installation - Network Setup - Planet WNRT-627 Schnellinstallationsanleitung

Step 2: Follow the figure below to connect network devices.
RJ11
Phone Jack
DSL/Cable Modem
4. Manual Installation – Network Setup
A computer with the UTP cable connected to the Wireless Router is required
for the first-time configuration.
Steps: Set your computer to get an IP address from the Wireless Router
(Based on Windows 7 and Windows 10):
1. Click the "Start" button located at the lower-left corner of your
computer.
2. Click "Control Panel".
3. Double-click the "Network and Sharing Center" icon.
4. Click "Change adapter settings".
5. Double-click "Local Area Connection".
6. Select "Internet Protocol Version 4 (TCP/IPv4)" and click
"Properties".
7. Select "Obtain an IP address automatically" and "Obtain
DNS server address automatically" and then click "OK".
Power
Power Adapter
RJ45
1-3
RJ45
PC/Laptop