System Audio SA2K Bedienungsanleitung Seite 2

Manual (English)
Thank you, for choosing SA. This manual will help you
getting correctly started with your new loudspeakers.
Follow the instructions of the manual to obtain the best
sound. Please, note that the loudspeakers needs 50 to 100
hours burn in before the sound is optimised. There are no
special precautions during the burn in period.
check the serial number
At the box for the loudspeaker you will find the serial number.
It is a good idea to write the serial number down on the invoice
from the dealer and save it together with your insurance
documents. Contact your dealer if there is no serial number on
the box.
connecting the loudspeaker to the amplifier
At the rear of the loudspeaker (pict. 1) you will find the input
terminal. This is where you connect the cable from the
amplifier output to the loudspeaker. The red terminal is positive
the black is negative. Make sure that the cable is correctly
connected so that + on the amplifier is connected to + on the
loudspeaker. The right and the left channel should also be
correctly connected. Make sure that the connection is solid
and clean.
If you use one cable per loudspeaker (single wiring), you must
connect the cable to both sets of terminals. You can also
choose to connect the loudspeaker with double cables. This
wiring principle is called biwiring.
biwiring makes the sound clearer
The biwiring principle means that the loudspeaker has two sets
of input terminals, and is constructed in separate bass driver
and tweeter sections. Thus you can use two cables per
loudspeaker i.e. one for the tweeter and one for the bass
driver. On the amplifier the two cables must be connected to
the same input terminal.
biwiring can be upgraded to biamping
Most modern amplifiers can be extended with an extra power
amplifier. This enables you to connect your existing amplifier to
the tweeter section and connect the power amplifier to the
bass driver section (pls. refer to your amplifier manual)
a good installation of the loudspeakers is vital to obtain a
good sound
Place the loudspeakers 2 or 3 metres apart from each other.
The sound from the loudspeakers should be able to find its
way to your preferred listening position unobstructed.
Be aware that:
•
the bass level is increased when the loudspeaker is
placed close to a wall, and reduced by making the
distance to the wall bigger
•
the sound gets clearer if the loudspeakers are
angled towards the listening position
•
the Tweeter units are mounted mirrored, so observe
that the Speakers has to be installed with the
Tweeters on both Speakers pointed to the middle
original accessories facilitate the installation
A compact loudspeaker can be freely placed anywhere. SA
has made it easy to use this freedom by having prepared your
loudspeakers for application of a floor stand, FS2K. See also
www.system-audio.com
cleaning the SA loudspeakers
The sides of the loudspeakers are cleaned with a moist cloth.
The front grill is carefully cleaned with a vacuum cleaner with a
brush mounted on the mouthpiece. Avoid touching the
membranes of the loudspeakers and do not use any strong
detergents.
this is how you make the most of your SA loudspeakers
•
Use some time experimenting with the position of
the loudspeakers
•
Give the speakers some time to burn in
•
The better your HiFi system is, the better your
loudspeakers sound
•
Good cables will improve the sound noticeable
•
Never play louder than it still sounds good
•
Remove the front grill for serious listening sessions.
•
Visit SA's Internet homepage
audio.com, where you can find more advice and
manuals.
System Audio A/S
Klosterengen 137 K
4000 Roskilde
Denmark
Internet: www.system-audio.com
SA is a registered trademark
Pict. 1
www.system-