Inhaltsverzeichnis
Werbung
FIGURE 1.
MOUNTING AND WIRING INSTRUCTIONS
GB
NOTE: Line art shown may not exactly match the fixture enclosed. However, the installation
instructions do apply to this fixture.
The light source of this luminaire is not replaceable; when the light source reaches its end of life
the whole luminaire shall be replaced.
CAUTION: For fixtures labeled for outdoor and wet location use, provide a water-tight seal
between the fixture and the mounting surface by using silicone or similar caulking.
1. Turn off power at circuit box to avoid possible electric shock.
2. Thread mounting screws (A) into mounting bar (B). Secure the mounting screws (A) with hex
nuts (C).
3. Place mounting bar flush against ceiling at desired mounting location. Using outside mounting
bar holes as a guide, mark where pilot holes are to be drilled.
4. Inset two plastic anchors (D) into the pilot holes (for drywall ceiling).
5. Align outside mounting bar holes with plastic anchors (D) (If applicable). Secure mounting
bar (B) into place using wood screws (E).
6. Open one link on bottom end of chain (F). Attach to loop (G1). Securely closed link on chain (F).
7. Lace wires up through every other link on chain (F) then through canopy (H) and nipple.
8. Open one link on top end of chain (F). Attach to loop (G2) on canopy (H). Securely closed link
on chain (F).
9. Make an electrical connection by loosening the terminal screws on the terminal block (M) and
inserting the live, neutral and ground terminals.
10. Tighten terminal screws. Make sure there are no stray wires.
11. Raise canopy (H) to ceiling, allowing mounting screw (A) to protrude through openings in
canopy (H) and secure into place with cap nuts (T).
12. Turn power back on at circuit box.
20
D
A
B
C
E
H
G2
T
G1
M
F
GS-26-FS28-WH19
Werbung
Inhaltsverzeichnis
