Operation; Power On/Off; Video Recording - Wiseup CHC100 Benutzerhandbuch

III. Operation
>> Before using, please make sure the Micro SD card is securely fitted into the SD card
slot on your
camera. The camera will not work without a Micro SD card. A SDHC Class 10 Micro SD
card (4GB-32GB) is recommended.

3.1. POWER ON/OFF

3.1.1. Power on the camera by plugging it into an outlet AC power socket.
3.1.2. Power the camera off by unplugging it.

3.2. VIDEO RECORDING

3.2.1. Before recording, make sure the Mode Switch stands next to the SD card slot.
3.2.2. Power on the camera by plugging it into an outlet AC power socket. The indicator
light will illuminate red for 3 seconds. Then it will flash red 3 times and go off, indicating
the camera is recording video automatically.
[Note]:
1). A video file will be generated and saved automatically every 10 minutes.
2). Video Resolution: 1920×1080P Video Format: AVI
3). Loop recording is supported.
4). If you have trouble in sliding the Mode Switch, please use a pin to help you do that.
5). If each video is less than 10 minutes, a video file will be saved but cannot be played back on
your PC computer.
3.3. MOTION DETECTION RECORDING
3.3.1. Before using, make sure the Mode Switch stands next to the indicator light.
3.3.2. Power on the camera by plugging it into an outlet power socket. The indicator light
will illuminate red for 3 seconds. Then it will flash red 3 times and go off, indicating the
motion detection function has been enabled already.
3.3.3. The camera will record video automatically when a movement is detected.
[Note]:
Each video clip lasts 2 to 3 minutes.