Verwandte Anleitungen für Barkan Flat/ Curved TV Long Dual Arm
Inhaltszusammenfassung für Barkan Flat/ Curved TV Long Dual Arm
- Seite 2 ATTENTION! Please read the following. WARNING! ATENÇÃO! ΠΡΟΕΙΔΟΠΟΙΗΣΗ! Disregarding the safety and assembly instructions may O não cumprimento das instruções de montagem e Η μη συμμόρφωση με τους κανόνες ασφαλείας και result in the falling of and/ or damage to your electrical segurança podem resultar na queda do aparelho ou causar συναρμολόγησης...
- Seite 3 UWAGA! PAŽNJA! ВНИМАНИЕ! Несоблюдение правил монтажа и инструкций по Lekceważąc bezpieczeństwo i instrukcje, doprowadzić Ne obaziranje na upozorenja o bezbednost i sklapanju безопасности может привести к падению и/ или można do upadku lub uszkodzenia urządzenia može imati za posledicu pad i/ ili oštećenja električnog повреждению...
- Seite 4 Внимание Caution Это изделие предназначено - This mount is intended for use only with the maximum для установки электроприборов weight as indicated. Using heavier products might cause injury. вес которых не превышает максимальный вес указанный в спецификации. Atención Forsigtig Pozor Установка...
- Seite 5 Do not install on walls and Ne szerelje fel falra vagy Забранено е инсталирането ceilings made of: gypsum board, mennyezetre, amely gipsz táblából, на гипсови стени и тавани,- drywall, light processed blocks, száraz falból, enyhén kidolgozott неизмазани стени, леки silicate boards/bricks, a damp tömbökből, szilikát táblákból/ блокове...
- Seite 6 Page 2 of 15 A A A A B B B B E E E E C C C C D D D D F F F F Z Z Z Z 5 5 5 5 + + + + Z Z Z Z 6 6 6 6 Z Z Z Z 7 7 7 7 G G G G H H H H...
- Seite 7 Page 3 of 15 2 2 2 2 Follow the steps according to your TV VESA (4 connection holes on the back of the screen) 2 2 2 2 A A A A For VESA 200x200, 200x100, 100x200mm (NO 100x100) Connect part C to the back of the TV, according to the VESA pattern and the depth of the screen connection holes Z Z Z Z 1 1 1 1...
- Seite 8 Page 4 of 15 2 2 2 2 B B B B For VESA 250x250… 600x400mm connect parts D to part C, using parts Z15, Z16, Z17 C C C C D D D D Z Z Z Z 1 1 1 1 6 6 6 6 Z Z Z Z 1 1 1 1 7 7 7 7 Z Z Z Z 1 1 1 1 5 5 5 5 For VESA 250x250…...
- Seite 9 Page 5 of 15 3 3 3 3 Check the location of the VESA pattern in relation to the back of the TV Determine the desired location of the center of the VESA pattern on the wall and mark it on the wall using a pencil and a level.
- Seite 10 Page 6 of 15 4 4 4 4 A A A A Wood stud wall: Find a stud in the wall, level part H according to the marked line on the wall, mark the holes according to the holes in part H, make sure all the marked holes are on studs and drill.
- Seite 11 Page 7 of 15 5 5 5 5 6 6 6 6 Connect parts E and F to part A by pushing them onto Connect parts Z10 to parts E and F the sides of part A and then pushing them towards the wall, until you hear a click.
- Seite 12 Page 8 of 15 1 1 1 1 0 0 0 0 1 1 1 1 1 1 1 1 Connect parts C and B using parts Z2 and Z8, Bring the TV with part C on its through the holes in part C and the back to part B, from the top down nut-housing in part B Z Z Z Z 8 8 8 8...
- Seite 13 Page 9 of 15 1 1 1 1 2 2 2 2 Follow the steps according to your TV VESA (4 connection holes on the back of the screen) 2 2 2 2 A A A A For VESA 200x200, 200x100, 100x200mm (NO 100x100) Connect part C to the back of the TV, according to the VESA pattern and the depth of the screen connection holes Z Z Z Z 1 1 1 1...
- Seite 14 Page 10 of 15 2 2 2 2 B B B B For VESA 250x250… 600x400mm connect parts D to part C, using parts Z15, Z16, Z17 C C C C D D D D Z Z Z Z 1 1 1 1 6 6 6 6 Z Z Z Z 1 1 1 1 7 7 7 7 Z Z Z Z 1 1 1 1 5 5 5 5 For VESA 250x250…...
- Seite 15 Page 11 of 15 3 3 3 3 Disconnect the 2 horizontal strips of part A. Separate the right arm from the left arm 4 4 4 4 In order for the center of the VESA pattern to be placed exactly in front of the corner of the wall, the right and left arms of part A should be placed on both sides of the corner, at the same distance from it.
- Seite 16 Page 12 of 15 5 5 5 5 A A A A Z Z Z Z 8 8 8 8 Z Z Z Z 7 7 7 7 5 5 5 5 B B B B Concrete, block and brick wall: place the wall plates on the marked line on the wall and level them. Mark the holes in the wall plates on the wall.
- Seite 17 Page 13 of 15 5 5 5 5 B B B B Z Z Z Z 8 8 8 8 Z Z Z Z 7 7 7 7 x Min 2 Min 4 Max 9 7 7 7 7 6 6 6 6 Connect parts E and F to the right and left wall plates by Connect parts Z10 to parts E and F pushing them onto the sides of each wall plates and then...
- Seite 18 Page 14 of 15 9 9 9 9 1 1 1 1 0 0 0 0 Place parts Z9 in the plastic nut-housing in part B Z Z Z Z 9 9 9 9 132lb / 60kg 1 1 1 1 0 0 0 0 1 1 1 1 1 1 1 1 Connect parts C and B using parts Z2 and Z8, Bring the TV with part C on its...
- Seite 19 Page 15 of 15 Disconnection of the TV from the mount: unscrew parts Z2 and Z8 parts B and C, lift the TV away from the mount...
- Seite 20 4800 Driling Template • Print this page without scaling (do not “fit to page”) • Verity the print scale by measuring the ruler below INCH 1” 2” 3” 4” 1/2” 1/2” 1/2” 1/2” 1/4” 3/4” 1/4” 3/4” 1/4” 3/4” 1/4” 3/4”...