Klarfit Husky Handbuch Seite 13

Full axle
Bicycles with quick-release axle
Remove the quick release from the bicycle and guide it through the trailer
coupling together with the quick release axle. Push the quick-release through
the wheel axle again, tighten the nut and clamp the quick-release with the
correct pressure. To ensure that the hub is suffi ciently clamped in the hollow
axle, the quick-release lever must engage in the middle position when moving
from the open position, and there must be clear resistance when approaching
the closed position. If it is too easy or too diffi cult to move the quick-release
lever, tighten or tighten it. Loosen the quick-release nut on the other side of
the hub.
WARNING
Risk of injury! The thread of the quick-release nut must be
tightened at least 5 full turns on the quick-release axle to
ensure suffi cient clamping force. If the quick-release axle is too
short, this can lead to unintentional loosening of the rear wheel
and thus to serious injuries or death. If in doubt, contact your
dealer.
After mounting
Insert the safety pin through the holes both in the coupling and in the coupling
connections. Turn and lock the pin. Wrap the seat belt around the chain stay
and attach it to the D-ring of the trailer coupling using the snap hook.
Quick-release axle
EN
13