Using The Machine; Chain Brake - Alpina A 3700 Gebrauchsanweisung

10
EN
Under normal circumstances the product should
be used in the normal operating mode, i.e., in
the mode which it is set at the time of shipment.
However when the possibility exists that icing
may occur, the unit should be set to operate in the
anti-freeze mode before use.
To switch from "Normal" mode to "Anti-freeze"
mode (and vice versa) (Fig. 11):
1. Switch the engine off.
2. Remove the air filter cover (1) and the air filter
(2).
3. Remove the choke (3) from the cylinder cover
(4):
4. Unscrew the screws (5) which secure the
cylinder cover in place (three screws inside
and one outside) and remove the cylinder
cover.
5. Use your fingers to press the anti-freeze cap
(6) on the right side of the cylinder cover and
slide it out from its seat.

7. USING THE MACHINE

To respect people and the environment:
– Try not to cause any disturbance.
– Scrupulously comply with local regulations
and provisions for the disposal of waste ma-
terials after sawing.
– Scrupulously comply with local regulations
and provisions for the disposal of oils, pet-
rol, damaged parts or any elements which
have a strong impact on the environment.
– A certain amount of chain lubricating oil is
released into the environment when the ma-
chine is running, so only use biodegradable
oils made specifically for this use. Use of a
mineral oil or motor oil causes serious dam-
age to the environment.
WARNING!
clothing when using the machine. Your dealer
can provide you with all the information on the
most suitable accident-prevention devices to
guarantee your safety. Wear anti-vibration
gloves. All the above-mentioned precautions
do not however guarantee the prevention of
certain risks – i.e. Raynaud's phenomenon or
Carpal tunnel syndrome. For operators who
use this machine for prolonged periods, it is
therefore recommended to have periodic
check-ups on the hands and fingers.
If any of the above mentioned symptoms
should appear, please contact a physician
immediately.
HOW TO START - USE – STOP THE ENGINE / USING THE MACHINE
Always wear suitable
6. Turn the anti-freeze cap (6) so that the
"SNOW" symbol is facing upwards and then
replace the cap.
7. Replace the cylinder cover and all the other
parts in their original position.
NOTE
anti-freeze mode at higher temperatures, this may
cause difficulties when starting the engine and
during use due to the incorrect engine speed.
Always check that the machine is switched to
normal mode (with the "SUN" symbol facing
upwards) if there is no danger of ice forming.
DANGER!
generates an average sized electromagnetic
field, but it is not however possible to exclude
the possibility of interference on any active or
passive medical devices that operators may
be wearing; this could be risky for their health
conditions. All those using medical devices
should always consult their GP, or the device
manufacturer, before using this machine.
WARNING!
use the machine for felling and delimbing.

CHAIN BRAKE

This machine comes with an automatic brake that
stops the chain when kickback occurs during cut-
ting.
This brake can be operated manually by pushing
the front guard forward. To release the brake, pull
the front guard towards the handgrip until you hear
a click.
WARNING!
the chain brake does not function correctly
and have it inspected by your dealer.
• Check that the chain brake is working
efficiently.
– Make sure you are holding the machine firmly
with both hands when you start the engine
If the machine is used in
This machine's starter unit
It takes specific training to
Do not use the machine if