Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN installation manual
Thank you for buying the LED floor lamp SDF-015.
Please read these operating instructions carefully
before first use. Like this, you avoid errors that could
cause malfunction.
1. Package contents
Please check the set is complete and no parts are faul-
ty or damaged before using it.
-
lamp head
-
lamp stand
-
ground
-
1.5 meter power cable with plug
-
4x Lid head screw 5x20mm (A)
-
4x Lid head screw 5x20mm (B)
-
operating instructions
2. Safety instructions
After unpacking you should check whether the
device is free of mechanical damage caused
during the transport. lf there is any damage,
please contact your reseller of the product. The
manufacturer is not liable for damages, resulting from
the unproper use of the product.
The assembly of the luminaire may only be carried out
by a qualified electrician under the consideration of
these operating instructions. Repairs may only be car-
ried out by the manufacturer or authorized personnel.
3. Scope of application
During installation, maintenance and repair work, turn
off the current circuit. The product has an IP20 degree
of protection, only used in the interior of buildings.
Protect the product from moisture, dirt and overhea-
ting. Never cover the product with thermally insulating
material. Use the product exclusively for the intended
purpose. The luminaire consists of non-replaceable
LED chip and power supply. Do not modify or disas-
semble the product and don't change anything on the
wiring. This lamp is only for connection to 230 V, 50 Hz.
4. Cleaning instructions
The maintenance of luminaires is limited to the
surface. There must be no moisture in connec-
tion rooms or on current carrying parts. Before
you clean the lamp, separate it, switch off the
fuse from the power cord and allow them to cool down.
Stubborn spots can be erased with a light damp cloth,
if necessary using a cleaning solution. Solvents or ab-
rasive /corrosive substances must not be used.
Tradingzone AG I Allmendstrasse 2 I 8105 Regensdorf I 044 833 33 55 I mail@tradingzone.ch I 10.10.2019
5. Operating Notes
-
press the button to increase the brightness
-
turn the product on or off by shortly pressing
the button.
-
press the button to lower the brightness
6. Movement detector
-
The product automatically turns on when some
movement is detected.
-
The product automatically turns off if no move-
ment is detected over a period of 8 minutes.
7. Disposal methods
After the end of the service life, please dispos-
se the product properly; it must not be mixed
with normal household waste. Led lights and
LED lamps must be properly disposed and re-
cycled. Hand in LED lights to your municipal
disposal company, dispose of the packaging sorted by
type. You get more Information on proper disposal at
your local authority.
Werbung
