Mounting - Panasonic AV-HS04M6 Bedienungsanleitung

Mounting

Install this board in the multi-format live switcher AV-HS400AN/AE (or AV-HS400N/E).
Note:
When installing this board to the AV-HS400N/E, the AV-HS400N/E system must be
upgraded to version 2.00.00 or higher.
Consult with your dealer about updating the system version.
<Notes>
p Be sure to ask the store or dealer where you purchased the product for assistance
with mounting and removal.
p Set to OFF and unplug the power connector before mounting and removal.
p Before handling this board, touch a metal part of the AV-HS400AN/AE (or AV-HS400N/E)
to discharge the static electricity from the human body.
An anti-static wrist strap is recommended for safety. Failures may be caused if you
touch this board while you are still charged with static electricity.
p Before installing this board, keep the metal parts of this board free of contact with
other metal parts.
p Be sure to mount the blank panel installed with the AV-HS400AN/AE (or AV-HS400N/E),
after removing this board.
p When installing or removing this board, take care not to hurt yourself on the edges
and metal parts of the boards.
Turn off the power of the AV-HS400AN/AE (or AV-HS400N/E), and unplug the power
cord.
Loosen the two screws of SLOT1 or SLOT2 on the input side at the rear of the
AV-HS400AN/AE (or AV-HS400N/E), and remove the blank panel.
10 (E)
SLOT2
SLOT1
Blank panel
Screw
Screw