Problem and solution:
LUMENIO LED mini/maxi does not react properly to the remote control.
The LUMENIO LED mini/maxi remote control uses infra-red technique which can be affected by
non-reflecting wall paints or dark curtains. To improve the remote control functions:
1. Make sure you are using new batteries.
2. Try to aim directly at the LUMENIO LED mini/maxi when using the remote control.
3. Reduce the distance between LUMENIO LED mini/maxi and remote control.
4. Try a different place for LUMENIO LED mini/maxi.
LED does not blink when pressing a key?
Replace batteries with 2 new "AAAA" alkaline batteries.
The remote control also runs the TV or other devices.
Remove the illuminant from the LUMENIO LED. Cut the transparent foil on the upper end of the
illuminant to reach the two switches beneath the sealing (the opening does not have to be closed again).
Delivery Status: the two switches on the bottom are set as shown in illustration "default". Alter switch
setting in order to change the remote control frequency:
Alternative 1
Code: 25155
If the power supply, the remote control or the illuminant is damaged, they must be replaced completely. Spare
parts can be ordered directly at your retailer, at www.lumenio.com or at our hotline +49 (0) 21 54-89 13-11.
Verwendung • Usage
www.lumenio.com
ON
1. Alter switch setting as shown in illustration
"Alternative 1/2".
2. To adapt the remote control to the new setting
follow instructions of chapter "manual code
1
2
setting". Replace the mentioned 5-digit code
Default
with the one of the new switch setting.
Code: 11233
In case your TV or other technical equipment
ON
ON
is still affected please use the alternative code
setting.
1
2
1
2
Alternative 2
Code: 31434
ON
1
2
Austausch des Leuchtmittels • Exchange of fluorescent lamp