Huawei VPC500S Handbuch

Appearance
▌
1
2
Lens: 10×optical zoom.
1
Status indicator:
2
status of the device (running, dormant, or
faulty).
displays device settings.
LCD:
3
2 6
HD-DVI interface:
2 6
COM OUT interface:
2 7
COM IN interface:
2 8
sent by the HD video terminal, and forward infrared signals.
Power interface:
2 9
Installation
▌
Place the camera on a flat surface.
If you have to place the camera on an inclined surface, ensure that the angle of the surface to the
horizontal is less than ±15 degrees so that the movement of the camera is guaranteed .
You can also use the following methods to install the camera:
Fix the L-shaped bracket (an optional accessory) on a wall. Then use adjustable screws (1/4"-20UNC) to fix
the camera on the L-shaped bracket.
Use a tripod to fix the camera, you must purchase a tripod separately.
Power the camera on.
The camera has no power switch. The camera powers on automatically after you connect all the cables and
power on the power module. After about 12 seconds, the camera's head turns to the position it was in
when it was last powered off.
Check the status indicator
Green: The camera is working properly.
Blinking in red or alternately in red and green: A mechanical problem occurs.
3
Indicates the operating
2 7 2 9
2 8
DVI/YPrPb video output interface.
maintenance interface.
used to connect a control cable to the camera, transmit control commands
used to connect a power cable to the camera.
MODE button:
2 4
Selects IR, VIDEO, or FLIP.
SET button:
5
2 4
Selects an operating mode.
5