Operation - Ayce EP-82M Gebrauchsanweisung

Recycle unwanted materials instead of disposing of them. All
appliances and packaging should be sorted and tendered at a
regional recycling centre into to be processed in an ecological
manner.
Proven safety of the federal inspectorate for heavy current
installations ESTI.
2. Product symbols
In this manual and/or on the machine the following symbols are used. These
represent important information about the product or instructions on its use.
750W
Rated output
750W
230/240V~50Hz
Rated Voltage
230/240
V~ 50Hz
17000/min
min
-1
Rotational speed
17000
Cutting width
0-82mm
0-82mm
180613_ayce_EP-82M_IM
Cutting depth 0-3mm
0-3mm
With a dust extraction
bag to suction the dust
3m cable with Swiss
plug
3M

OPERATION

1. Before use
• Remove any packing material and loose parts from unit.
• Check the accessories before use. It should be fit with the machine and your
purpose.
2. Functions
a. Setting the depth (Fig.1)
Fig. 1
b. Parallel Stop (Fig.2)
! Always ensure that the machine is switched off and plug is removed
from the power supply before making any adjustment.
WARNING
Fig. 2
82 83 |
• You can adjust the depth in variables
of 0.25 mm from 0 to 3 mm by turning
the setting knob for the depth.
• Turn the setting knob for the depth in
a clockwise direction to set a greater
depth.
• Turn the setting knob for the depth in
a counter-clockwise direction to set a
lower depth.
• After finishing work, set the depth so
that the blades are lowered and thus
protected from damage.
• Turn the setting knob for the depth to
position "P" for this purpose.
• The parallel stop is secured to the
side of the machine by using parallel
stop knob.
• Adjust the distance from the blade
and secure with locking nut.
NOTE: as it is a guide, make a test cut
•
on a scrap of timber prior to making
any cut on the work piece.
180613_ayce_EP-82M_IM
GB
GB