Control Panel; Recirculation Mode - Pyramida WH 10-50 Montage- Und Bedienungsanleitung

Do not forget to include the hood as soon as you start to use
the oven or hob. It is necessary for proper ventilation kitchen.
For a complete ventilation, turn off ventilation hood is not
earlier than 15 minutes after the cooking process.
Hood is equipped with front panel control, which is a series
of buttons. By buttons «•», «• •», «• • •» the gear shifting.
When heating food enough work hood on low speed. For
standard conditions of preparation (cooking and frying for
1-2 burners) used average speed.
When working in recycle mode exhaust clean air back into
the kitchen.
To switch from ventilation to recirculation mode to air:
- Redirect the air flow inside the hood of the duct to the
shutters on the upper surface of the hood.
Switching the direction of airflow implemented effected
by the switching regulator of damper on the fan housing.
To access the regulator must remove the fat filters.
- Install a carbon filter in hood. Carbon filter is not supplied
and sold separately.
1 2 3 4 5
High speed is intended to remove from the premises of
a large amount of steam, and the mixed smell of cooking,
working simultaneously all the burners.
Switching speed buttons can be performed in any order.
To turn off the fan, use the button «0».
Carbon filters can not be cleaned and replaced with new
every 3-4 months.
In hood Pyramida WH 10-50, WH 20-60, GH 20-60 slim
sets a carbon filter. In the hood Pyramida WH 22-60 – two
filters.
Regime of recirculation

contRol PAnel

1. To turn on or turn off the
backlight.
2. To turn off the fan.
3. To turn on low speed of the
fan
4. To turn on average speed of
the fan
5. To turn on high speed of the
fan

ReciRcUlAtion mode

Regime of ventilation
31