Attaching The Plasma Television; Installing The Product On A Rack Etc - Pioneer PDK-TS30 Bedienungsanleitung

Attaching the Plasma Television

The weight of a plasma television is about 55.5 kg
(122.4 lbs), they have no depth, and are unstable.
Therefore, at least two people must assemble and
Caution
install them.
Note
Be sure to install it on a flat stable location.
Insert the screws in the holes vertically and do not tighten
them with more force than necessary.
Place a sheet or other material under the display to
prevent scratches or damage to it.
After manually turning the screw lightly two or three
times, tighten it with a screw-driver.
1
Attaching the plasma television to the
stand.
Lay the plasma television down flat. Align the stand
supports with the plasma television stand slots, and slowly
insert the supports horizontally.
Please ensure that the stand supports do not come into
contact with anything other than the plasma television
stand slots. Contact with any other area may result in
scratching or deformation of the display's rear side or
terminals.
Rear
Front
Note
When laying down the plasma television, be careful so as to
not scratch or damage it.

Installing the Product on a Rack etc.

Caution
When installing on a
rack etc., please be sure
that the plasma
television is held by
two or more people.
Please do not hold the
plasma television by
the speakers or stand.
Doing so may damage
the product.
2
Note
Please stand the plasma television upright after installing the
stand.
Hold the plasma
television by its handles
and from the top.
Securing the plasma television with
Installation screws 2 (M6 × 20 mm: black).
Please tighten the screws with a Phillips screwdriver.
Rear
Front
Do not hold the plasma
television by the
speakers.
2
Installation screws
(M6 × 20 mm: black)
Do not hold the plasma
television by the stand.
11
En