Advanced Settings - Z-CAM MT4029 Gebrauchsanleitung

Note: any higher then VGA resolution will decrease
transmisson speed (fps) due to USB bandwitch.
Recording a video
Open AMCAP, click the "Capture" then "Start Capture",
specify fi lename and patch then click „OK" to start cap-
turing. Select "Stop Capture" to fi nish recording.
EN

Advanced settings

Open AMCAP, select "Options" and then "Video capture
fi lter" – following window will appear.
„Settings" tab
Here you can adjust basic image corrections. You can
also choose „low light" when working in dark condi-
tions or choose frequency to match your power grid
freqency rate (50Hz or 60Hz).
"Eff ect" tab
Here you can select image eff ect and image frame for
captured video.
„Face tracking" tab
Here you can enable „Face tracking" function.
Note: „Face tracking" works only in VGA mode.
Setting focus
To adjust focus rotate lens ring to left/right to achieve
desired focus range.
Precautions
Do not touch camera lens with hand, sharp or coarse
stuff , always use clean and soft cloth for cleaning.
Do not use it in extremely hot, cold, dusty or humid
circumstances.
Avoid mechanical shocks not to damage the glass
lens.
Note: Heat emission is a normal eff ect when web-
cam is working.
Camera Specifi cation
High Resolution CMOS Sensor
Max transmission rate: up to 30fps@640x480
Still image capture up to 8 Mega pixels
with software interpolation
Image focus: 3cm to infi nity
Non-Compression Image Processor
AWB (Automatic White Balance)
Manual Focus Function
Built-in Microphone
Face tracking function (software enabled)
Photo frame function (software enabled)
Interface: USB2.0