Maintenance And Cleaning - K&H Sanitary 110-0070 Montage-, Bedienungs- Und Sicherheitshinweise

§ Setting the temperature
limiter
The cartridge in this unit has a temperature
17
limiter. This function is not activated in the factory
(neutral setting).
m
CAUTION! Change the temperature limiter
setting only after the tap has been installed.
Follow Fig. E to set the temperature limitation.
Turn off the main water supply.
Remove the plastic cover
small flat screwdriver.
Release the locking screw
anti-clockwise using a hexagonal key.
m
CAUTION! Do not take the locking
screw completely out; just loosen it until
12
the control lever
11
Take off the control lever
Loosen the cartridge end ring
then screw off the cartridge locking ring
by using a pipe wrench.
Now pull the adjusting ring
the help of a screwdriver.
Note: Do not remove the cartridge
Place the adjusting ring
position (see Fig. G).
Note: The adjusting ring
turning angle of the handle, so that the
amount of hot water can be limited.
Tighten the cartridge locking ring
tap body again by using a pipe wrench. Then
tighten the cartridge end ring
Place the control lever
body. Tighten the locking screw
it clockwise using a hexagonal key.
Press the plastic cover
Turn on the main water supply and check the
temperature limiter.
carefully by a
13
by turning it
12
can be easily taken off.
.
11
by hand,
14
15
upwards with
16
.
17
in the desired
16
can limit the
16
onto the
15
by hand.
14
back on to the tap
11
by turning
12
into the opening.
13
§ Maintenance and cleaning
§ Tap care and cleaning
Please note that sanitary fittings require special
care and attention. Therefore you should follow
the following advice:
Never use corrosive or alcohol-based
materials for cleaning, as these could
damage the product.
Clean your fittings with clean water, mild
detergent and a soft cloth or leather only.
Screw out the mixer nozzle
intervals and remove lime deposits or foreign
bodies.
Non-observance of the above care advice can
be expected to result in damage to the surface
of the fittings. In this event your rights under the
warranty may be invalidated.
§ Disposal
The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.
at regular
10
GB 7