Powering The Unit; Front Panel; Rear Panel - Klark Teknik DN9610 Bedienungsanleitung

10 DN9610 AES50 Repeater

3.4 Powering the unit

◊ ◊
To ensure redundancy, each DC inlet is to be sourced from its
own separate branch circuit. Otherwise, their mains sources
must be suitably distributed so as to meet local safety
regulations.
The DN9610 is powered on/off via the mains outlet(s).
Note: A dual redundant power supply is not supplied.
A
Typical dual redundant mains power connection.
A. Lockable power supply unit connector. B. Mains outlet socket (UK
version shown). C. Power supply unit country variant plug attachment
(UK version shown).
klarkteknik.com

4. Front Panel

(1)
Rugged Neutrik EhterCON chassis AES50 'input' connectors 1
and 2.
(2)
Green LEDs for indicating the activity on AES50 output ports
1 and 2.
(3) Green LEDs for indicating the activity on AES50 input ports 1
and 2.
(4)
POWER LED to show when the power is on.

5. Rear Panel

B
C
(5) DC inlet power sockets for accepting lockable power supply
input connectors. You only need to connect one PSU to operate
the unit. However, for redundancy connect two PSUs (only one
PSU supplied).
(6)
AES50 OUT 2 rugged Neutrik EhterCON chassis AES50 'output'
connector.
(7)
AES50 OUT 1 rugged Neutrik EhterCON chassis AES50 'output'
connector.
1 2
1 2
3 2 4
3