Technical Specifications; Important Safeguards - ARESA AR-3303 Bedienungsanleitung

ENGLISH
After unit transportation or storage at low temperature it is necessary to keep it for at least 4 hours at room temperature before switching on.
Supply voltage: 220-240 V ~ 50 Hz
Power consumption: 35 W
Please read this instruction manual carefully before use and keep in a safe place for future reference.
• Before the first connecting of the appliance check that voltage indicated on the rating label corresponds to the mains voltage in your home.
• For home use only. Do not use for industrial purposes. Do not use the appliance for any other purposes than described in this instruction manual.
• Do not use outdoors.
• Always unplug the appliance from the power supply before cleaning and when not in use.
• To prevent risk of electric shock and fire, do not immerse the appliance in water or any other liquids. If it has happened DO NOT TOUCH the
appliance, unplug it immediately and check in a service center.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety.
• If the appliance is used in a bathroom, it should always be unplugged after use, because nearness of water is dangerous even if the appliance
is switched off.
• For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30 mA is
advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.
• Children should be supervised to ensure that they do not play with the appliance.
• Do not leave the appliance switched on when you do not use it.
• Do not use other attachments than those supplied.
• If the power cord is damaged it should be replaced by the manufacturer or authorized servicing center or qualified professional for safety reasons.
• Do not attempt to repair, adjust or replace parts in the appliance. Repair the malfunctioning appliance in the nearest service center.
• To protect against the risk of burn, do not touch detachable plates.
• Keep the cord away from sharp edges and hot surfaces.
• If the product has been exposed to temperatures below 0ºC for some time it should be kept at room temperature for at least 2 hours before turning
it on.
• The manufacturer reserves the right to introduce minor changes into the product design without prior notice, unless such changes influence
significantly the product safety, performance, and functions.
CAUTION:
• Be careful, the device becomes very hot during operation.
• The device is to be used only on dry clean hair or towel-dried hair.
ATTENTION! Do not use the device beside the bathrooms, swimming pools and other vessels containing water.
• Production date mentioned on the unit and/or on the packing materials and documentations.
Be carefu during operation, do not allow the heating element of the device to come into contact with unprotected skin. The working area is
heated to 220 ° C.
Attention: Place the device on a level, stable and heat-resistant surface.
Avoid touching heated surfaces with a power cord.
Your new device has a protective coating of the heating element. At the first start-up and heating, a short, brief smoke and odor may
appear. It is safe to use and does not mean a defect of the device. When using it for the first time, wait until smoke and odor cease. This can last
no more than 30 seconds.
Operation mode of the device: after 30 minutes of operation, break for at least 15 minutes.
Wash the hair before setting it. For achieving the best result thoroughly wash the hair after using hair conditioner. Dry the hair with a towel.
• It is recommended to use a detangler before operating the device.
• Do not manipulate the same strand of hair for too long.
• When setting your hair manipulate hair strands evenly.
Unwind the power cord to the full.
• Connect the appliance to the mains.
• Set the ON/OFF switch to "ON" position. The operation indicator will light.
• After a few minutes the device will heat up.
• Separate the hair strand width of 2-4 cm.
• Hold a strand between the working surfaces of the heating elements. One working surface of the cylinder is two, the other - one. With these
cylinders wave comes naturally.
• Move from the roots to the tips.
After the use don't touch the plates, leave them to cool.
TRANSPORTATION. Transportation of the device is necessary by any kind of covered transport with the application of cargo securing rules
ensuring preservation of the
presentation of the product and / or packaging and its further safe operation. DO NOT expose the device to shock loads during handling
operations.
CLEANING. The device doesn't need maintenance and doesn't contain any parts that require user intervention.
For cleaning, first disconnect the device from the mains supply, let them cool down. Always clean only fully cooled hair-straightener. Wipe the
handle with a soft, slightly damp cloth. Do not allow water to enter the handle.
STORAGE. The device must be stored indoors, in conditions that presume the preservation of the presentation of the product and its further safe
operation. Make sure that the appliance and all its accessories are completely dried, before storing it. To avoid damaging the cord, do not wind it
or hang by the power cord.
Please read this instruction manual carefully before using the appliance.
This device is designed for for modeling and styling hair. For household use, not suitable for industrial use.
The device is intended for use only for domestic purposes in accordance with this Instruction Manual.

TECHNICAL SPECIFICATIONS

IMPORTANT SAFEGUARDS

OPERATION
Save the instruction manual as you may require it in future.
Service lifetime - 3 years
Warranty period - 12 months