Battery Charger; Charging Procedure - GreenWorks Tools 2901207 Bedienungsanleitung

If the battery pack cracks or breaks, with or without
leaks, do not recharge it and do not use. Dispose
of it and replace with a new battery pack. DO NOT
ATTEMPT TO REPAIR IT!
To avoid injury and risk of fire, explosion, or electric
shock, and to avoid damage to the environment:
·
Cover the battery's terminals with heavy-duty adhesive
tape.
·
DO NOT attempt to remove or destroy any of the
battery pack components.
·
DO NOT attempt to open the battery pack.
·
If a leak develops, the released electrolytes are
corrosive and toxic. DO NOT get the solution in the
eyes or on skin, and do not swallow it.
DO NOT place these batteries in your regular household
trash.
·
DO NOT incinerate.
·
DO NOT place them where they will become part of
any waste landfill or municipal solid waste stream.
·
Take them to a certified recycling or disposal centre.

BATTERY CHARGER

SPECIFICATIONS
80V charger: 2902507 (VDE plug), 2904007 (BS plug)
Input: 230V a.c. 50-60Hz, 2.5A
Output: 80V d.c. 4A

CHARGING PROCEDURE

NOTE: The battery is not shipped fully charged. It is
recommended to fully charge before use to ensure that
maximum run time can be achieved. This lithium-ion
battery will not develop a memory and may be charged
at any time.
1. Plug the charger into an AC power outlet.
2. Insert the battery pack (1) into the charger (2).
English (Original Instructions)
WARNING
WARNING
2
This is a diagnostic charger. The Charger LED Lights will
illuminate in specific order to communicate the current
battery status. They are as follows:
LED STATUS
Blinking Green
Solid Green
Solid Red
Blinking Red
False Defect Note:
When the battery is inserted into the charger, and the
status LED flashes, remove the battery from the charger
for 1 minute, then reinsert. If the status LED indicates
normal than the battery pack is good. If the status LED
is still blinking, remove the battery pack and unplug the
charger. Wait 1 minute and plug the charger back in
and reinsert the battery pack. If the status LED indicates
normal than the battery pack is good. If the status LED is
still blinking then the battery pack is defective and needs
to be replaced.
NOTE: When the red indictor flickers, pull out the battery
from the charger and insert again within 2 hours. If the
indictor shows charging, that means the battery is good.
After 2 hours, please pull out the battery and also pull
out the AC power plug of the charger for 1 miniute, and
then insert the AC power plug and the battery again. If the
indictor shows charging, that means the battery is good. If
not, the battery needs to be changed.
CHECKING THE CHARGER
If the battery pack does not charge properly:
4
1
DESCRIPTION
Charging
Fully Charged
Over Temperature
Charging Fault