Specific Safety Instructions - Perel Tools PD05001 Bedienungsanleitung

• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• When using an extension cord, make sure the wires are at least 1mm². Do not use extension cords on a reel.
• Only use the device for its intended purpose. Using the device in an unauthorised way will void the warranty.
• Always make sure you are in a stable position while using the PD05001/PD050012.
• Make sure you can never touch water, electricity or gas lines while drilling.
• Do not use the PD05001/PD050012 in the vicinity of flammable vapours and substances.
• Vibrations can damage the arm-hand system. Keep exposure to vibrations as short as possible.
• Check the voltages marked on the rating plate and verify it matches your mains voltage.

3. Specific Safety Instructions

• Drill bits may be flung out of the device accidentally and cause serious injury. Before starting work, always check
that the drill bit is properly locked in the chuck. Examine the chuck regularly for signs of wear or damage and never
start up a drill until it is pressed against the wall.
• Always disconnect the device from the mains before changing a chisel or drill bit. After use, disconnect the device
from the mains and remove the chisel or drill bit.
4. Description
The PD05001/PD050012 has been designed for drilling wood, metal, plastic, stone and concrete as well as for screw
driving applications.
1. Side handle
2. Depth stop
3. Chuck
4. Lock button
5. ON/OFF switch
6. Speed adjustment
7. Forward/reverse switch
8. Hammer drill selection switch
PD05001/PD050012 2 PEREL