MARIMEX ProStar Vac Smart Anweisungen Seite 6

EN
Prostar Vac SMART vacuum
Instruction
Hammer-head semi-automatic pool vacuum for non-recessed pools. Cleans the
bottom of the pool. Minimum pump flow rate from 3.1 m
depth of 80 cm to 135 cm. Package includes a 5.6 m hose. The vacuum cleaner is
completely composed and can be connected directly. Before starting the vacuum
cleaner, check the lower disk for proper locking. Parts list - figure 1
Connecting the vacuum cleaner
Turn off filtration. Use a suitable reduction (G) on the wall passage or skimmer.
Can be connected straight to the passage, without reduction. Then connect the
short blue hose (A) and the pivot pin (B). Next, connect the hoses at the end of the
manual
For swimming pools with a diameter of 366 cm - figure 2
For swimming pools with a diameter of 457 cm - figure 3
For swimming pools with a diameter of 549 cm - figure 4
Completely drain the hoses to remove all air and reconnect the hose to the vacuum
cleaner. If air remains in the filter, bleed it out. With a flow rate of more than
3.8 m /h, we recommend using a control valve.
3
If the vacuum cleaner stops sucking or is slow, check that your filtration has a
proper flow. Check for air in the hoses or filter and possibly bleed the filter. Make
sure the vacuum cleaner disk is in the correct position. If the vacuum cleaner does
not vacuum, change the hose (E).
The warranty terms are governed by the Marimex CZ, s.r.o. at www.marimex.cz.
Print errors are reserved
zakaznickecentrum@marimex.cz
6
Contact
http://www.marimex.cz
Custome Centre
tel.: +420 261 222 111
/h. For pools with a
3