Inhaltsverzeichnis
Werbung
EN
EN
DESCRIPTIONS
1 - Last song & volume up
2 - Multifunction button (MFB)
3 - Next song & volume down
Charging the battery with USB cable
FUNCTION DESCRIPTION
• Step1: Insert USB charging cable into USB port of PC.
• Step2: Connect charging cable with the charging port of headset.
Turning On of device : Long press2 second on
•
• When the red light is on, the headset is charging.
prompt "Power ON".
• When the red light is off, the headset is charged fully.
Turning off of device : Long press2 second on
•
• It takes about 2 hours to charge the headset fully.
prompt "Power Off".
Warning:
PAIRING STATUS
• The battery is rechargeable.
• First time charging : Before you use this headset, please charge the
1- First time pairing : Boot into pairing mode automatically,
battery of headset fully
Voice prompt"the bluetooth device is ready to pair".
Equipment open bluetooth connection interface option
A ) How to enter pairing mode
"EBFLATBK / EBFLATWH"clik connect, no password .
Be sure BH-06 in power off status first. Press and hold the MFB for
After the success of the matching voice Prompt"The bluetooth
8 seconds, till Red and blue Led blink alternately, or you hear the
device is connected successfully".
indication "Pairing" . And then release the MFB. The unit will become
pairing mode.
2- Re-pairing : Under off status long press
B ) Pairing the headset with mobile phone
red and blue LED flash alternately.
Please make sure your mobile phone has function that can be used.
3- For already connected device ,bluetooth headphone will
Specific pairing procedures were not the same with different mobile
automatically back to connect.
phone. Please refer to your mobile phone manual for further informa-
tion. Steps as follows:
Headphones into the matching status again .
1- Please keep the headset and mobile phone in the range of 1 meter
when pairing.
OPERATION GUIDE
2- Start the function of mobile phone and search the devices.
Get through --------------------------------Short press
3- Make the headset enter into pairing mode (Please refer to "how to
Hang up -------------------------In a call short press
enter into pairing mode").
• After searched, select "BH-06"in the device list.
Replay the last phone number -----------Double-click
- According to indication, enter password or PIN No:"0000", and
Play/Pause Music --------------------Short press
Volume control to up and down ----Short press
- After successful pairing, select "BH-06" in the device list, and
Song switch to up and down ----------Long press
- After successful connecting, the blue LED of the headset quickly
LED LIGHT STATUS
1- Charging status -----Long bright red light,full charged red
Notes: If the headset is in standby mode and does n't connect to any
light was off.
devices, BH-06 will power off automatic 8 minutes later.
2- Device on prompt-----Blue light on
EBFLATBK-Notice_6x16cm.indd 10
Notice-EBSPBK_2.indd 10
4
5
press the key of " Yes" or "confirmed".
press "connect".
blinks twice.
1
5
1
4
6
6
4 - LED Indicator
5 - Built-in microphone
6 - Charging port
10
10
2
3
2
3
, Voice
, Voice
about 2 second,
25/04/2017 16:31
17/04/2015 10:00
Werbung
Inhaltsverzeichnis
