Werbung
3. Prepunched Boards
Fig.2
4. Assembly
Fig.3
The gears (P4-7) should be placed to the left of the pinion gear (P3). Put one N-shaped nylon connector (P12)
downward and the other one upward. Insert the motor according to the drawing's direction. Note that the protruding
edge should point towards the metal case.
Fig.4
Mount switch P18 to side board W28. Screw fixing plates P26 and P27 to side boards W28 & W29, then fix them to
board W27. Mount the gearbox on top of board W27.
KNS2
VELLEMAN
- 2 -
Werbung
