Installing/Replacing The Lamps - Beamz 151.250 Gebrauchsanleitung

MIRROR BALL
INSTALLATION IN PRIVATE PREMISES
- WARNING: A falling mirror ball can cause serious injuries!
- A mirror ball is meant to create decorative light effects in combination with an appropriate light
source.
- ATTENTION!! Mirror balls need to be installed by a professional according to the European standard
EN60598.
- The installation that supports the mirror ball (including the motor) needs to be able to carry during 1
hour 5 times the weight of the mirror ball without showing visible distortion.
- Use a chain of sufficient strength to link the motor to the mirror ball. Do not use steel cable that might
fray due to the torsion.
- Big mirror balls need to be secured by a safety net.
- The mounted motor and mirror ball assembly needs to be checked regularly, and at least once a
year by a professional.
- Check regularly the chain between the motor and the mirror ball, including the fixing points on the
motor and the ball.
INSTALLATION IN PUBLIC PREMISES
- WARNING: Mirror balls need to be installed according to the European standard EN60598-2-7 and
the standards which are applicable in the different countries. The installation might only be done by a
professional installer!
- The installation that supports the mirror ball (including the motor) needs to be able to carry during 1
hour 10 times the weight of the mirror ball without showing visible distortion.
- The installation needs to be secured by a safety net so that no parts can fall down.
- IMPORTANT! THE INSTALLATION OF LIGHT EFFECTS REQUIRES EXPERIENCE and
knowledge of load calculations, installation materials, periodic safety checks, etc. Leave the
installation to a professional if you don't have the required knowledge and experience. A wrong
installation might cause serious injuries and material damages.
- Use a chain of sufficient strength for the link between the motor and the mirror ball. Do not use steel
cable that can fray under the torsion.
- DANGER: Prior to the first use of the motor and mirror ball assembly, the installation needs to be
checked by a professional.
- The motor and mirror ball assembly needs to be checked regularly by a professional.
- Check regularly the chain between the motor and the mirror ball, including the fixing points on the
motor and the mirror ball.
PAR36 SPOT WITH COLOUR WHEEL

Installing/replacing the lamps

Before replacing the lamp, unplug mains lead and let the lamp cool down. Please follow the lamp
manufacturer's notes when installing.
- You need one 6V 30W Par 36 Lamp for installation.
- Please remove the fixation ring by pressing it together.
- If replacing the lamp, remove the old lamp from the pin spot and loosen the wires.
- Loosen the screws on the new 6V 30W Par 36 lamp with an appropriate screwdriver.
- Connect the wires with the lamp using an appropriate screwdriver.
- Tighten the screws.
- Insert the lamp in the housing.
- Fix the lamp with the fixation ring.
Mounting the Colour Wheel
- Unscrew the nut and the first tooth ring from the fixation axle of the colour wheel motor.
- Remove the foil of the colour wheel.
- Slip the colour wheel onto the fixation axle of the motor
- Slip the tooth ring first and then the nut onto the fixation axle.
- Fasten the nut without damaging the colour wheel.
- Fix the colour wheel with motor via the fixation on the motor to the pin spot housing and tighten the
screw.