ELV Elektronik WS300 Bedienungsanleitung Seite 55

BA 65 01 55 04.05.2004
• Insert the rainfall sensor into its holder. It will hold the
count rocker firmly automatically.
Only one orientation is correct; the cable of the rain-
fall sensor and the magnet of the count rocker have
to be on the same side; the plastic nib on the other
side has to be inserted precisely into the holder, look
at the circle in the picture on the right.
• Place the cone collector from the top onto the sensor carrier and snap it in by turning it to the left.
• Push the lower part of the rain gauge housing upwards and lock it by turning it to the right until it snaps
in.
The drain holes in the lower part of the housing have to point to the outside so that the water does
not run on to the metal stands.
7:19 Uhr Seite 55
55