Chapter 1 - Control Panel; Chapter 2: Preparation For Use - Hoover SFM4001 Handbuch

Chapter 1 - Control Panel

On/off switch (1A)
A light on the switch will illuminate to indicate that the appliance is switched on.
When the appliance is switched on and "Steam ready" light (1c) is off, it means
that steam is ready. You can press the steam trigger and steam will escape from the
soleplate. Please note that during use, the steam light will switch on but you can
continue steam ironing.
"Water tank empty" light (1b) is on: There is no more water in the tank.
Please refill the tank following the instructions in the chapter 2.2

Chapter 2: Preparation for Use

Due to the powerful output of steam, Hoover recommends the use of an active iron-
ing board with blowing and vacuuming function which allows escape of any excess
steam.
Place the ironing system on a stable and level surface, for example on the hard part of
an ironing board or on a heat-resistant surface.
Chapter 2.1 : What Kind of Water May be Used?
The Hoover ironing system has been designed to be used with tap water only.
There is no need to use distilled or pure distilled water.
Nevertheless, in case you live in a hard water area, you can mix 50% of distilled water
with 50% of tap water.
Do not use any other kind of water or do not add any contents to water tank as it can
damage your appliance.
Chapter 2.2 : Filling the Water Tank
Switch off the appliance and unplug it.
Open the water tank filler cover (3) to gain access to the water tank.
Fill it with tap water with the help of a bottle.
Do not exceed the max mark.
Fig. 4: Water Tank Filling
Warning: Do not add vinegar, hot water, perfume, or any other kind of chemical
agents or any other contents in the water tank. It could damage the steam generator
and shorten its life use.
5 - GB